9fans archive / 1995 / 08 / 53 /    prev next

From: presotto@pla... presotto@pla...
Subject: Plan9 and mice
Date: Sat, 5 Aug 1995 09:59:49 -0400

Without parameters the aux/mouse assumes the mouse is on serial port 0,
we number them 0 and 1 unlike DOS's 1 and 2.

Other than that, it's the same.

------ original message follows ------

>From cse.psu.edu!9fans-outgoing-owner Sat Aug  5 09:38:53 EDT 1995
Received: by colossus.cse.psu.edu id <45523>; Sat, 5 Aug 1995 09:14:56 -0400
Received: from sol.we.lc.ehu.es ([158.227.6.42]) by colossus.cse.psu.edu with SMTP id <45514>; Sat, 5 Aug 1995 09:14:40 -0400
Received: from sirius.we.lc.ehu.es by sol.we.lc.ehu.es (5.x/SMI-SVR4)
	id AA03262; Sat, 5 Aug 1995 15:13:44 +0200
Date:	Sat, 5 Aug 1995 09:13:44 -0400
From:	borjam@we.... (Borja Marcos)
Message-Id: <9508051313.AA03262@sol...>
To:	9fans@cse...
Subject: Plan9 and mice
Sender: owner-9fans@cse...
Precedence: bulk
Reply-To: 9fans@cse...


	Hello,

	I have just installed the 4 floppy distribution (and I'm waiting
impatiently to receive the complete system I've ordered :-) ).

	I had a problem with the miec I tested. One of them is a Genius 
HiMouse (serial, Mouse-Systems type) which works flawlessly with XFree86,
and a Dexxa mouse, also Mouse Systems compatible in COM1. Neuther of them
worked when I told the system to use COM1. It said "Unknown mouse
type". However, I tried to execute "aux/mouse" WITHOUT any parameters
and it works now. After editing the rc script which loads the driver, the system
is working fine. What is the difference if I don't give parameters to the mouse
driver?

	The rest of the installation has gone well, without any problems. I'm
looking forward to receive the complete system so that I acn make a permanent
installation.

	Thank you very much, Bell Labs, for bringing another interesting
operating system; perhaps in ten years it will be widespread? :-)


	Borja Marcos.
	borjam@we....